Classification Of Plain Cloth

Plain Cloth

Plain cloth structure is formed by the interlacement of warp and weft yarn in the alternative order. So, all plain cloth has the same design but it is possible to modify the appearance of the cloth by adding some properties to the fabric structure. So, we should be careful during the weaving process to apply the decorative techniques to the plain cloth.

Classification Of Plain Cloth

There is a lot of plain fabric is found in the market but they have some technical differences in their structure. The main effective factor is Ends Per Inch (EPI) and Picks Per Inch (PPI). Then it can be classified in the following two ways.

  1. Plain Cloth is classified depending on the face of the cloth
  2. Plain cloth is classified depending on the balance of the cloth

The Face of the Cloth

Depending on the face of the cloth, plain cloth is classified as follows:

  • Approximately Square Cloth: This type of fabric is formed by same warp and weft count; also, EPI and PPI are same.  In its structure, warp and weft are equally or nearly prominent on both sides of the cloth. Cheesecloth, surgical cloth, and Tracing cloth are approximately square plain cloth.
  • Warp-Faced Cloth: This type of fabric is formed by fine warp yarn which is finer than weft yarn. Here, prominence of warp yarn is greater than that of weft yarn. Terylene, Shirting, Cotton Poplin, and cotton canvas are the most famous warp-faced cloth.
  • Weft Faced Cloth: In this fabric structure, prominence of weft yarn is more than that of warp yarn also weft yarns are normally finer than warp yarn. Cotton casement cloth is the most used weft faced cloth.

Balance of the Cloth

Depending on the balance of the cloth, plain cloth is classified as follows:

  1. Balanced Cloth: In this cloth, the warp and weft counts are the same. EPI and PPI are also the same. The prominent warp and weft are equal.
  2. Unbalanced Cloth: This type of fabric is formed by varying the warp and weft count, EPI and PPI, in the same structure.

From the above, we see that the fabric structure generally varies based on the count of warp and weft and the EPI and PPI of fabric.

So, when you will manufacture a plain cloth, try to classify it as the above.

Leave a Comment

*